NTI
Connect Extra Device
On the front of the RACKMUX is an additional USB Type A port to be used, if desired, for an extra accessory. Any low or full speed USB device may be connected to this port to be used. This port is fully compliant with USB standard 1.1.
Note: In order for the optional USB device port to be usable, the USB port on the rear of the RACKMUX must be connected to a USB enabled CPU (a 2 meter USB cable is supplied).
Note: If a USB keyboard or mouse is connected, operation of the RACKMUX keyboard or mouse may cause unpredictable results. Do not try to use both mice or both keyboards at the same time.
FRONT VIEW OF
Connect optional USB 1.1 or 2.0 device
| CAMERA |
|
PRINTER | SCANNER | FLASH DRIVE |
Figure 7- Connect a USB 1.1 device to the front (optional)
Note: If a USB 2.0 device is connected to the optional USB device port, it will operate at USB 1.1 speed.
Connect Power
Connect the IEC power cord to the power port as shown below.
REAR VIEW OF
NTI | NETWORK |
TECHNOLOGIES | |
INCORPORATED | |
1275 Danner Dr |
Aurora, OH 44202
www.networktechinc.com
IEC Powercord
Figure 8- Connect the power cord
Power Up
Power up the RACKMUX and connected computer in this order.
1.Power On the RACKMUX
2.Power ON the attached CPU.
If a device is plugged into the USB port on the front of the RACKMUX, it can
Note: During
6