Sun Microsystems HP LTO4 manual Replacement

Page 23

Removal and Replacement

3. Place the drive and drive tray on a suitable work surface.

Caution:

Potential ESD damage: The encryption card contains ESD-sensitive components. Make sure you follow proper ESD precautions.

4.Remove the two T9 screws from the top cover and remove the cover.

5.Remove the connectors from the HBD card.

6.Remove the four T10 screws that attach the drive to the tray.

7.Remove the T10 screw that attaches the encryption card.

8.Pull out the drive part way to gain access to the cables and connectors.

9.Remove the cable/connectors in this order:

Ethernet cable

P5

P6

Power cable

Signal cable

10.Remove the four T10 screws that fasten the card to its plate.

Replacement

Caution:

ESD-sensitive components. Make sure you follow the proper precautions.

Use care not to damage the thin, glass cable attached to J5. This cable is fragile and easily damaged.

To replace the Dione card:

1.Obtain the encryption card and remove it from its wrapper.

2.Align the card on the plate and insert the T10 mounting screws.

3.Connect P5 and P6 to the card.

4.Plug in the following cables in this order:

Signal connector from the card to the rear of the drive

Drive power (from rear of the drive)

Power jumper

5.Insert the card and plate into its position and fasten it with one T10 screw.

6.Position the HBD card back into place.

7.Re-connect the cables to the HBD card.

8.Insert the drive and fasten it to the tray with four T10 screws.

9.Replace the top cover plate and fasten it with two T10 screws.

10.Insert the drive tray into its slot in the array.

11.Reconnect the cables to the rear of the drive.

316196601 • Revision: A

Chapter 2 Dione Card 15

Image 23
Contents Sun StorageTekTM Crypto Key Management System Page Crypto Key Management System Version USA Contents Iv KMS LTO4 Technical Brief June Revision a Chapter Use this chapter to PrefaceOrganization Related InformationPartners Site Additional InformationSun’s External Web Site Documentation and Download Web SitesIntroduction 1LTO4 Tape Drive in Drive Tray-SL8500 Drive TrayPower SpecificationsPhysical Specifications Performance SpecificationsDescription Specification SpecificationCapability Native Capacity Length Format Write Read CompatibilityPart Number Description Order NumbersLTO4 Encryption Key Marketing Number Description Part Numbers DescriptionComponent Dione CardFirmware Requirements 1Dione Card Components Dione Card ComponentsGreen LED operation Connecting to the Dione CardReset Switch operation Key Lifecycle KMS OperationsDetails Potential issueWork-Around Media Types Media Rfid Chips4KMS Manager Data Unit List Removal Removal and ReplacementReplacement Page 1shows an example of the VOP Display Virtual Operator PanelOperating System Certification Enable and disable encryptionVOP Prerequisites Computer Hardware RequirementsCustomer Using VOPService Version Document Files Posted File SizeTIP Start VOP5Commit-Passed 10.0.0.5 Diagnose Drive Tab Run LED Diagnostic Test8Run LED Diag Run Loopback TestLoad Firmware Get LogDiagnose Drive Tab KMS LTO4 Technical Brief June RevisionA Index Scsi interfaces, 1 SDP Page Headquarters