Sun Microsystems HP LTO4 manual 10.0.0.5

Using VOP

During the commit process, the tape drive goes offline then IPLs to save the new settings to the Dione card.

Important:

When the drive comes back online, it is now using the new IP address.

8.To continue with the configuration and to “enroll” the tape drive, you must connect the drive to the KMS network. The KMS must be able to communicate with the tape drive to complete the enrollment process.

Note – The Agent must be already created with a pass phrase assigned in the KMS before you can enroll the drive. If you were to “Unenroll” the Agent—for example: To turn encryption off, then re-enroll the agent to turn encryption back on—the pass phrase must be re-entered or the agent recreated in the KMS before re-enrollment.

9.Enter the new IP address in the connection window and click Connect (10.0.0.5 for this example).

FIGURE 3-6

10.0.0.5

10.0.0.5

10.Select the Configure Drive tab. The new settings are shown in the display.

11.Click “Enroll.”

12.Click on the Diagnose Drive tab to observe the enroll process.

■The enroll process takes about 40 seconds to complete.

■When the enrollment is complete, the button now indicates Unenroll.

■You would use this button to unenroll the tape drive; which would turn encryption off (see the note in Step 8).

22 KMS: LTO4 Technical Brief • June 2008 Revision:A • 316196601