Sun Microsystems T6320 service manual FRU-namedeemed faulty and disabled

TABLE 2-1Diagnostic Flowchart Actions (Continued)

Action			For more information, see
No.	Diagnostic Action	Resulting Action	these sections

7.	Determine if the	If the fault message displays the following text, the
	fault was detected	fault was detected by the Solaris Predictive Self-
	by PSH.	Healing software:

Host detected fault

If the fault is a PSH detected fault, identify the faulty

FRU from the fault message and replace the faulty

FRU.

After the FRU is replaced, perform the procedure to clear PSH detected faults.

8.	Determine if the	POST performs basic tests of the server module
	fault was detected	components and reports faulty FRUs. When POST
	by POST.	detects a faulty FRU, it logs the fault and if possible

takes the FRU offline. POST detected FRUs display the following text in the fault message:

FRU-namedeemed faulty and disabled

In this case, replace the FRU and run the procedure to clear POST detected faults.

Section 2.7, “Using the Solaris Predictive Self- Healing Feature” on page 2-42

Section 4.2, “Common Procedures for Parts Replacement” on page 4-3

Section 2.7.2, “Clearing PSH Detected Faults” on page 2-45

Section 2.7.3, “Clearing the PSH Fault From the ILOM Logs” on page 2-46

Section 2.6, “Running POST” on page 2-31

Section 4.2, “Common Procedures for Parts Replacement” on page 4-3

Section 2.6.4, “Clearing POST Detected Faults” on page 2-39

9.	Contact Sun for	The majority of hardware faults are detected by the
	support.	server module diagnostics. In rare cases it is possible
		that a problem requires additional troubleshooting.
		If you are unable to determine the cause of the
		problem, contact Sun for support.

Sun Support information:

http://www.sun.com/ support

Section 1.3, “Finding the Serial Number” on page 1-11

2-6Sun Blade T6320 Server Module Service Manual • June 2009