Philips HTS3578W Change speaker settings, Menu, then press, To exit the menu, press Setup

Change speaker settings

Ideally, the distance between listening position and all the speakers should be the same. If not, change the speaker settings based on their distance from the listening position to obtain the best possible surround sound.

Audio Setup

Speakers Volume

Speakers Delay

HDMI Audio

CD Upsampling

Audio Sync

1	Press DISC.
2	Press	SETUP.
3	Press	to select [Audio Setup] in the

menu, then press .

•If the speaker setup option is not accessible, press twice before you try the above steps again.

To set the speakers level

1 Select [Speakers Volume] in the menu, then press .

Speakers Volume Setup

Front Left	0dB
Front Right	0dB
Center	0dB
Subwoofer	0dB
Rear Left	0dB
Rear Right	0dB

2 Press to change the volume level, then press OK.

»The test tone is emitted from the speaker.

•Repeat the above setting for other speakers until all the speakers’ output level sounds equally balance.

•To exit the menu, press SETUP.

To set the output delay time (centre and rear speakers only)

1 Select [Speakers Delay] in the menu, then press .

Speakers Distance Setup

Center	0MS
Rear Left	0MS
Rear Right	0MS

2 Press to set the delay time, then press OK.

•Repeat the above setting for other speakers until the sound output from different speakers reach the listening position at the same time.

•To exit the menu, press SETUP.

Tip

•Set a longer delay time if the centre speaker or rear speaker is closer to the listening position than the front speaker.

•Allow 1ms setting for every 1 foot distance between the speaker and the listening position.

22EN