Philips HTS3578W user manual Hdmi Audio Selects the Hdmi audio setting when you, With a Hdmi cable

[Speakers Volume]

Sets the volume level of each speaker to get the ideal audio balance.

1)To start, press OK.

2)Select a speaker in the menu, then press to adjust the volume level.

3)Press OK to confirm and exit.

Note

•The test tone is emitted from the speaker which you adjust.

[Speakers Delay]

Sets the delay time for the centre and rear speakers if they are placed closer to the listening position, so that the sound output from all speakers reaches the listening position at the same time.

1)To start, press OK.

2)Select a speaker in the menu, then press to set the delay time.

3)Press OK to confirm and exit.

Note

•Allow 1ms setting for every 1 foot distance between the speaker and the listening position.

[HDMI Audio]
Selects the HDMI audio setting when you	lish
connect this Home Theater System and the TV
with a HDMI cable.	Eng
• [On] – Allows audio output through the
TV and the speaker system. If the audio
format on the disc is not supported, it	settings
(linear-PCM).
will be downmixed to two-channel sound
• [Off] – Disables audio output from the	Adjust
TV.The sound is only output through the
speaker system.

[CD Upsampling]

Converts the music CD to a higher sampling rate using sophisticated digital signal processing for better sound quality.

•[Off] – Disables CD-upsampling.

•[88.2kHz (X2)] – Converts the sampling rate of the CDs twice as high as the original rate.

Note

•CD upsampling is only available in stereo mode.

[Audio Sync]

Sets the default delay time for audio output when you play a video disc.

1)To start, press OK.

2)Select a speaker delay in the menu, then

press to set the delay time. 3) Press OK to confirm and exit.

EN 41