Paradyne TAM1500-12 manual Default Settings, Management Password Administration Defaults

Page 3

!192.168.254.252 if the MUM is in slot 13 (IPD12000) or slot 5 (IPD4000)

!192.168.254.253 if the MUM is in slot 14 (IPD12000)

e.Log in with a default username and password (both of which are case sensitive). Please note that General Users have "read only" access; for NMS configuration you must log in as a Superuser.

!general / Password

!superuser / Password

NOTE Once accessed initially, the management system within the MUM can be configured such that NMS and SNMP can be reached from any computer on your network. For further instruction please refer to the Management User Guide for IP and Mini DSLAMs.

Accessing TAM1500-12 data in a previously installed IP DSLAM

a.Establish a connection with the MUM either directly (through the Ethernet RJ45 MGMT port on the MUM faceplate) or, if the system has been so configured, from a PC on your network.

b.For direct connections verify that the MGMT LNK LED on the MUM faceplate is illuminated indicating the connection has been established.

c.Launch a web browser such as Microsoft Internet Explorer (v4.0 or higher) or Netscape Navigator (v4.0 or higher).

d.Enter the assigned IP address* into the address field at the top of your browser window. Press the Enter key.

e.Log in with your assigned username and password.* Please note that General Users have "read only" access; for NMS configuration you must log in as a Superuser.

*If the IP address, username or password is unknown, contact your System Administrator or Information Technology Manager.

Default Settings

No configuration is necessary for the TAM1500-12 to operate at default settings. If however, a change is required, default settings can easily be modified within NMS. For information regarding specific parameter configurations, refer to the TAM1500-12 Circuit Configuration section on the following page and/or the Management User Guide for IP and Mini DSLAMs.

Management Password Administration Defaults*

General Username:

general

Super Username:

superuser

General Password:

Password

Super Password:

Password

*Usernames and passwords are case sensitive.

210-0000025 rev04

Image 3
Contents Installation Install the TAM1500-12 in an IP Dslam chassisUnpack and inspect the TAM1500-12 Connect the T1 Lines T1 RJ21 Connector Port PinoutAccessing TAM1500-12 data in a newly installed IP Dslam OverviewManagement Password Administration Defaults Default SettingsTAM1500-12 Circuit Configuration Data StorageSpeed Frame Type Line CodeTx Transmit Buildout LED Indicators Additional InformationTiming Transmitting T1 AL AlarmRegulatory Compliance T1 TXCorporate Drive, Suite 1, Portsmouth, NH