Option Description Integrated NIC, USB Controller | Dell T5600

Table 3. System Configuration

Option	Description

Integrated NIC	Allows you to configure the integrated
	network controller. The options are:
	•	Disabled
	•	Enabled (Default Setting)
USB Controller	Allows you to control the USB controller. The
	options are:
	• Enable USB Controller (Default
		Setting)
	• Disable USB Mass Storage Dev
	•	Disable USB Controller
Serial Port	Identifies and defines the serial port settings.
	You can set the serial port to:
	•	Disabled
	•	Auto
	•	COM1 (Default Setting)
	•	COM2
	•	COM3
	•	COM4
	NOTE: The operating system may allocate
	resources even if the setting is disabled.
SATA Operation	Allows you to configure the internal SATA
	hard-drive controller. The options are:
	•	Disabled
	•	ATA
	•	AHCI (Default Setting)
	NOTE: SATA is configured to support RAID
	mode.
USB Configuration	Allows you to define the USB configuration.
	The options are:
	• Enable Boot Support/Front USB Ports/
		Rear USB Ports/USB3 Ports
SMART Reporting	This field controls if the hard drive errors for
	the integrated drives are reported during
	system startup. This technology is part of the
	SMART (Self Monitoring Analysis and
	Reporting Technology) specification.

• Enable SMART Reporting - This option is disabled by default.

41

Image 41

Dell T5600 owner manual Option Description Integrated NIC, Enable USB Controller Default, Serial Port, Sata Operation

Contents

Regulatory Model D01T Regulatory Type D01T001 Dell Inc Contents Diagnostics System SetupTroubleshooting Your Computer Technical Specifications Contacting Dell Before Working Inside Your Computer Working on Your Computer After Working Inside Your Computer Turning Off Your Computer Recommended Tools Removing and Installing ComponentsRemoving the Power Supply Unit PSU Removing the Cover Installing the Power Supply Unit PSU Removing the Optical Drive Installing the CoverPage Page Removing the Thermal Sensor Installing the Optical Drive Removing the Hard Drive Installing the Thermal SensorPage Installing the Air Tunnel Installing the Hard DriveRemoving the Air Tunnel Removing the Memory Removing the Coin-Cell Battery Installing the MemoryInstalling the Coin-Cell Battery Removing the Heat Sink Installing the Heat Sink Removing Heat Sink Fan Installing the Heat-Sink Fan Removing the Processor Installing the Processor Removing the System Fan Page Page Page Page Removing the PSU Card Installing the System FanPage Removing the Front Bezel Installing the PSU Card Removing the Front Input/Output I/O Panel Installing the Front BezelPage Removing the Speaker Installing the Front Input/Output I/O Panel Removing the System Board Installing the SpeakerPage Page System Board Components Installing the System BoardPage Page Memory Module Guidelines Power Supply Unit PSU LockAdditional Information Page Boot Sequence System SetupNavigation Keys Keys Navigation Boot Sequence System Setup OptionsBoot List Option Option Description System Board USB Configuration Enable USB Controller DefaultEnable Smart Reporting This option is disabled by default Option Description Integrated NIC Default Setting Enable Intel SpeedStep Option Description PCI Bus ConfigurationDefault Setting Enable Intel TurboBoost Non-Uniform Memory Access Admin Password Enable Intel Virtualization Technology Default SettingSystem Password Strong Password Option Description AC Recovery Admin Setup LockoutChassis Intrusion Auto On Time Updating the Bios Password Type Description System and Setup PasswordPassword that you must enter to log on to your system Setup password Disabling a System Password Page Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Diagnostic LEDs Troubleshooting Your ComputerPage Page Error Message Error Messages Error Message Page Feature Specification Technical Specifications SAS USB Video Video card dependent DVI connector DisplayPort DMS-59 Sata Temperature Operating To 35 C 50 F to 95 F Cm/sec 20 in/sec Page Visit support.dell.com Contacting Dell