Paradyne 8546 installation instructions DSL Slot, Port # Tip, Ring

HotWire 8600 DSLAM Telco 50-pin Connector Pinouts for DSL Loops and POTS Splitters

25

1The Telco 50-pin receptacle on the front panel provides the two-wire loop interface from each 8546 DSL port to either the POTS Splitter shelf or, if the

loop is not being shared with POTS, then to the MDF. The following table lists the pin assignments for each of these interfaces.

26NOTE:

50

97-15526

When the 8600 chassis is the base chassis, the MCC is installed in Slot 1 and the Tip and Ring wiring for Slot 1 is not active.

Also, pins 13 through 25 and 38 through 50 of all HotWire 8600 chassis are not used.

CONNECTOR	CONNECTOR PINS
(8546 DSL Slot, Port #)	(Tip, Ring)
Slot 1, Port 1	1, 26
Slot 1, Port 2	2, 27
Slot 1, Port 3	3, 28
Slot 1, Port 4	4, 29
Slot 2, Port 1	5, 30
Slot 2, Port 2	6, 31
Slot 2, Port 3	7, 32
Slot 2, Port 4	8, 33
Slot 3, Port 1	9, 34
Slot 3, Port 2	10, 35
Slot 3, Port 3	11, 36
Slot 3, Port 4	12, 37

10 October 1997 8546-A2-GN10-20