Paradyne 8546 installation instructions On a HotWire 8800 Dslam chassis

ÐOn a HotWire 8800 DSLAM chassis:

SLOTS 13-18
SLOTS 7-12	LINES

SLOTS 1-6

Anchor Mount

Shorter

Telco

Captive Screw

Telco 50-Pin

Connector

LINES

SLOTS 1-6

97-15325

2.Replace the longer Telco cable captive screw with a shorter connector captive screw, which is provided with the HotWire DSLAM chassis.

3.Insert a cable tie (provided with HotWire DSLAM chassis) through the tie mount to hold the Telco 50-pin connector in place. If more than one Telco cable is being connected, replace the existing cable tie with a single tie to span the two or three connectors.

4.Make sure the other end is connected to the appropriate POTS splitter shelf, MDF, or demarcation point.

Refer to Pin Assignments on page 9 for pinouts.

NOTE:

If you are connecting the Telco 25-pair, 50-pin cable to an MDF without a POTS splitter in the line, a converter may be necessary for terminating the other end of the cable on a punchdown block before cross-connecting to an MDF.

8546-A2-GN10-20 October 1997 7