Paradyne 8300 installation instructions Connecting the CBR Port, Connecting the Network Port

Page 7

Connecting the CBR Port

The CBR (Constant Bit Rate) port is an RJ48C, eight-pin modular jack that is software-selectable for T1 or E1. As a T1 port, it terminates as 100 ohms, and as an E1 port at 120 ohms. This port is used to transport TDM traffic using a T1/E1 framer to provide ATM adaptation Layer 1 with Circuit Emulation Services (AAL1-CES). It must not be connected to outside plant wiring.

Procedure

1.Plug an RJ48-to-RJ48 cable (not provided) into the CBR port.

2.Plug the other end of the cable into your T1 or E1 equipment.

Connecting the Network Port

The NETWORK port is a standard RJ49C, eight -pin modular jack that terminates as 135 ohms.

Procedure

1.Plug the 8-pin modular cable (provided) into the NETWORK port.

2.Plug the other end of the cable into your DSL interface.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Product Documentation Online ContentsPreparation Package ChecklistProcedure Installing the Power CordIndicator Description Front Panel LEDs and SwitchesConnecting the Supervisory Port Connecting the Serial Port Connecting the Ethernet PortConnecting the Network Port Connecting the CBR PortWeb Interface Accessing the Web Interface United States EMI Notice Canada EMI Notice Important Safety Instructions Supplier’s Declaration of Conformity Warranty, Sales, Service, and Training InformationTrademarks Document FeedbackPage 8300-A2-GN10-00
Top Page Image Contents