Installing the Power Cord
The POWER port on the unit is a standard, grounded,
Figure 1. Hotwire 8300 Endpoint Back Panel
Procedure
1.Insert the power cord’s receptacle into the POWER jack.
2.Plug the other end of the power cord into a grounded power outlet.
3.Check the LEDs.
When power is applied to the unit, the front panel indicators flash for approximately 10 to 15 seconds as the unit initializes itself. The green POWER LED on the front panel remains on as long as the unit receives power. If the indicator does not light up, check the power connections and the primary circuit breaker.
Figure 2. Hotwire 8300 Endpoint Front Panel
3