Patton electronic 2884 manual WAN Ports, Ethernet Ports, Management, Protocols

Page 40

IpLink 2884/2888 Getting Started Guide	B • Specifications

WAN Ports

2 or 4 software conﬁgurable channelized ports

E1 – G.703/G.704 with HDB3 and AMI encoding support

T1 – ANSI T1.403 & AT&T TR54016 with AMI coding/D4 framing or B8ZS coding/ESF framing

Ethernet Ports

Two-port 10/100/1000Base-T (RJ-45 connector)

Auto-negotiating

Half or full duplex operation with built-in MDI-X

Management

HTTP/SNMP

Telnet/SSH Ethernet

CORBA Management Plane

RS-232 Console Port

SYSLOG Client

Software upgrade via TFTP

Protocols

IP (RFC 741)

TCP (RFC 793)

UDP (RFC 768)

ICMP (RFC 950)

ARP (RFC 826)

IGMP v1 and v2, Ethernet Bridging

PPP/BCP

IEEE 802.1p/Q VLAN Tagging and Priority

Model 2884 only: IP Router with RIP (RFC 1058) and RIPv2 (RFC 2453), integrated DHCP Server (RFC 2131) with selectable IP leases and MAC/IP pairings

Model 2884 only: NAT/NAPT with integrated application support, MultiNat with 1:1 mapping, Many:1, Many:Many mapping, NAT Port/IP redirection and mapping

Model 2884 only: PPP/IPCP

WAN Ports

40

Image 40

Contents IpLink Mailsupport@patton.com Summary Table of Contents Table of Contents Initial configuration Cabling List of Figures List of Tables Audience About this guideStructure Precautions Safety when working with electricityGeneral observations Typographical conventions used in this documentGeneral conventions Node Chapter contents General informationIpLink Model 2884 Overview IpLink ModelIpLink Model 2888 Overview Model 2884 Features Features and BeneﬁtsModel 2888 Features Rear and Front Panels IpLink 2884/2888 rear panelLAN ETH IpLink 2884/2888 front panel LEDApplications overview Typical IPLink 2884 Application Typical application for IPLink ModelTypical IPLink 2888 Application IpLink installation Planning the installation Network DiagramSite log Network informationInstalling the IpLink 2884/2888 Installing cables Connect the cables in the following orderConnecting the power supply Connecting DC Power to the 288x DC Power Supply Initial conﬁguration Connecting and logging in via the Ethernet port Connecting the IpLink to your PCIntroduction Factory-default IP settings Connecting and logging in via the Console portConﬁguring the desired IP address Login Connecting the IpLink to the networkChanging the IP address Contacting Patton for assistance Contact information Warranty coveragePatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information Safety Compliance Radio and TV Interference FCC Part 68 Acta StatementCE Declaration of Conformity Industry Canada NoticeAuthorized European Representative Appendix B Speciﬁcations WAN Ports Ethernet PortsManagement ProtocolsSecurity Power SupplyPhysical Appendix C Cabling Connecting a serial terminal ConsoleEthernet Connecting an E1 port to an NT1 E1 PortConnecting a T1 port to an NT device T1 PortAppendix D Port pin-outs Console port EIA-561 RJ-45 8-pin portT1/E1 port Appendix E End user license agreement End User License Agreement Termination Other licenses

Related manuals

Manual 51 pages 18.45 Kb