Patton electronic 2158A, 2168A Appendix C, 10/100BASE-T Interface, RJ-45, Copperlink Interface

Page 24

APPENDIX C

COPPERLINK SERIES INTERFACE PIN ASSIGNMENT

C.1 10/100BASE-T INTERFACE

RJ-45

•Pin 1: TX+/RX+

•Pin 2: TX-/RX-

•Pin 3: RX+/TX+

•Pin 6: RX-/TX-

•Pins 4, 5, 7, 8: no connection

C.2 COPPERLINK INTERFACE

RJ-45

•Pin 4: RING

•Pin 5: TIP

•Pins 1, 2, 3, 6, 7, 8: no connection

Terminal Block

See Figure 4 on page 11.

24

Image 24

Contents

User Manual Contents Distance Chart, Based on 24 AWG 0.5 MM Warranty Information Safety ComplianceCompliance EMC ComplianceService Radio and TV Interference FCC PartCE Declaration of Conformity Authorized European RepresentativeSafety When Working with Electricity Within 10 feet 3 meters of the device, shall beFeatures General InformationDescription Typical applicationInstallation Unit InstallationConnecting the TWISTED-PAIR Line Interface Grounding the Copperlink Ethernet ExtenderNo connection Model 2168A Model 2158A Connecting the ferrite clamp to the terminal block Model 2168A/TB45Connecting the 10/100BASE-T Ethernet Interface Do not connect power to the DC Mains at this time Connecting PowerConfiguration Configuring the Hardware DIP SwitchesConfiguring DIP Switch SW Power UP OperationFront Panel LED Status Monitors LED DescriptionLED is solid yellow and the CopperLink Link LED LED Status Indicators Appendix a LAN Connection Transmission LinePower Supply Temperature RangeDimensions HumidityAppendix B Patton Model # DescriptionPower Supplies Appendix C 10/100BASE-T InterfaceRJ-45 Copperlink InterfaceAppendix D Symm Line Rate Distance in feet kmAsymm Line Rate DS/US Distance in feet km Page Page Copyright Patton Electronics Company All Rights Reserved