Patton electronic 1052 user manual Configuration, Configuring the Hardware DIP Switches

3.0 CONFIGURATION

The Model 1052 is equipped with 16 DIP switches that enable configura- tion of the unit for a wide variety of applications. This section describes switch locations and explains the different config-urations

3.1 CONFIGURING THE HARDWARE DIP SWITCHES

S1 and S2 each contain eight internal DIP switches (see Figure 1) that are used for configuration reset purposes only. To access switch set SW1, use a small flat blade screwdriver to open the Model 1052’s case as shown in Figure 2 on page 8.

Push toggle up for ON position

Push toggle down for OFF position

S1

							S2
							ON
				1	2
			ON			3	4
1							5	S2
	2	3					6
							8
							7
			4
			5	6
					7
						8
						S1

				ON
	1	2
Switch toggle			3
				4
				5
				6
				7
				8

ON

1 2 3 4 5 6 7 8

Figure 1. DIP switches S1 and S2

To configure the DIP switches, use a small screwdriver and gently push each switch to its proper setting. The ON and OFF positions are shown in Figure 1.

7