Patton electronic 1004ABRC user manual Cable Recommendations, Wire Gauge Capacitance Resistance

Page 12

APPENDIX B

PATTON ELECTRONICS MODEL 1004ABRC

CABLE RECOMMENDATIONS

The Patton Model 1004ABRC operates at frequencies of 115kHz or less and has been performance tested by Patton technicians using twisted-pair cable with the following characteristics:

Wire Gauge

Capacitance

Resistance

19 AWG

83nf/mi or 15.72 pf/ft.

.0163 Ohms/ft.

22 AWG

83nf/mi or 15.72 pf/ft.

.0326 Ohms/ft.

24 AWG

83nf/mi or 15.72 pf/ft.

.05165 Ohms/ft.

To gain optimum performance from the Model 1004ABRC, please keep the following guidelines in mind:

Always use twisted pair wire—this is not an option.

Use twisted pair wire with a capacitance of 20pf/ft or less.

Avoid twisted pair wire thinner than 26 AWG (i.e. avoid higher AWG numbers than 26)

Use of twisted pair with a resistance greater than the above speci- fications may cause a reduction in maximum distance obtainable. Functionality should not be affected.

Many environmental factors can affect the maximum distances obtainable at a particular site. Use the above data rate/distance table as a general guideline only.

APPENDIX C

PATTON ELECTRONICS MODEL 1004ABRC

FACTORY REPLACEMENT PARTS

The Patton Model 1004ABRC rack system features interchangeable rear half cards, power cords/fuses for international various operating environments and other user-replaceable parts. Model numbers and descriptions for these parts are listed below:

Patton Model #

Description

1000RPEM

120/240V Rear Power Entry Module

1000RPSM-2

120/240V Front Power Supply Module

1000RPEM-DC

DC Rear Power Entry Module

1000RPSM-48A

48V Front Power Supply Module

1000RPEM-V

120/240V CE Compliant Rear Power

 

Entry Module

1000RPEM-V

120/240V CE Compliant Rear Power

 

Supply Entry Module

0805US

American Power Cord

0805EUR

European Power Cord CEE 7

0805UK

United Kingdom Power Cord

0805AUS

Australia/New Zealand Power Cord

0805DEN

Denmark Power Cord

0805FR

France/Belgium Power Cord

0805IN

India Power Cord

0805IS

Israel Power Cord

0805JAP

Japan Power Cord

0805SW

Switzerland Power Cord

0516FPB1

Single Width Blank Front Panel

0516FPB4

4-Wide Blank Front Panel

0516RPB1

Single Width Blank Rear Panel

0516RPB4

4-Wide Blank Rear Panel

21

22

Image 12
Contents User Manual Section Radio and TV InterferenceService FeaturesCE Notice DescriptionFront Card Configuration Switch Settings Modem aSwitch SET S1 Switch SET S2 Switch Settings Modem BSwitch SET S3 Switch SET S4 Rear Card Configuration Rear Card Strap SettingsInterface Card Strap Summary Table #1 Sgnd & Frgnd JB5Rack Power Supply DTE as DSR or RI JB6 & JB7Model 1000R16 Rack Chassis Installing the Model 1004ABRC Into the Chassis SignalRS-232 Connection Twisted Pair ConnectionSignal PIN# Signal PIN# XMT+Multipoint Twisted Pair Connection Host First Slave Second SlavePOWER-UP Patton Electronics Model 1004ABRC SpecificationsLED Status Monitors Wire Gauge Capacitance Resistance Patton Electronics Model 1004ABRC Factory Replacement PartsCable Recommendations Patton Model # DescriptionPatton Modular Interface 10 Wire RJ-45 Patton Electronics Model 1004ABRC Interface PIN Assignments