Patton electronic MODEL 2707/I user manual Operation, Power-Up, LED Status Monitors

6.0 OPERATION

When the Model 2707/I has been properly configured and installed, it should operate transparently. This section describes power-up, LED sta- tus monitors, and the built-in loopback test modes.

6.1 POWER-UP

Before applying power to the Model 2707/I, please review section “Power Connection” on page 15 to verify that the unit is properly connected to the appropriate power source.

6.2 LED STATUS MONITORS

The Model 2707/I features six front panel LEDs that monitor connections on the G.703 and 10Base-T links, signaling, error and test modes. Figure 11 shows the front panel location of each LED. Table 2 on page 18 lists descriptions of each LED.

10Base-T

Figure 11. 2707/I front panel

17