Patton electronic 07MSN4400-QS quick start Connecting power and configuring the default IP address

SmartNode 4400 Quick Start Guide

Connecting a PC, logging in, and configuring the LAN IP address

Connecting power and configuring the default IP address

Connect the SmartNode to the mains power supply using the included power supply and cable. When the RUN LED stops blinking and remains lit, the SmartNode is ready.

The factory default IP settings are listed in table 1. If these addresses do not work with your network they must be changed. Contact your network administrator if you are not sure which IP address to use in

your installation.

Table 1. Factory default IP address and network mask configuration

Item	IP Addresss(es)	Network Mask
WAN interface Ethernet 0 (ETH 0/0)	DHCP	DHCP
LAN interface Ethernet 1 (ETH 0/1)	192.168.1.1	255.255.255.0
DHCP server address range	192.168.1.10-192.168.1.19	255.255.255.0

Note The DHCP server is running on the ETH 0/1 of the SN4400 Series models. All Ethernet ports are pre-configured and active.

Connecting to a PC and logging in

1.To access the SmartNode configuration, connect a PC equipped with an RS-232 console port to the Con- sole port on the front of the SmartNode. Use the included black Ethernet cable and RJ45 to DB-9 adapter for this purpose (Model 16F-561).

	240V
	- Hz)
100-60
(501	AMP

Reset

Ports

Console

Console port

0/0

ETH

0/1

ETH

Model 16F-561

adapter and cable

Laptop PC

Figure 2. Connecting to the PC

2.Open a Terminal connection to the SmartNode. Use the Terminal program included with most PC operat- ing systems (e.g. Hyper Terminal on Windows). The CD-ROM also includes some recommended termi- nal programs.

Connecting a PC, logging in, and configuring the LAN IP address 5