Patton electronic 2707/I user manual +Vin

Page 16

DC Power. The 36–60 VDC DC-to-DC adapter supplied with the DC ver- sion of the Model 2707/I plugs in a DC source (nominal 48 VDC) and plugs into the barrel power supply jack on the rear of the 2707/I. Refer to Figure 10 to make the proper connection.

To power	To -48 VDC
supply jack	source
	+Vin
	-Vin

Figure 10. Connecting DC power to the 2707/I DC power supply

16

Image 16

Contents User Manual Warranty Information ConfigurationInstallation SpecificationsFactory Replacement Parts and Accessories Warranty Information ServiceRadio and TV Interference CE NoticePage General Information FeaturesDescription PPP Operational Background ApplicationsModel 2707/I Model 2707/C Router Internet Ethernet LANDIP Switch Configurations ConfigurationFront Rear Switch S1 settings Switch Description SettingSW1-1 Line Coding HDB3 default SW1-1 Line EncodingPage Installation Connecting to the G.703 Network and Ethernet LANConnecting Dual Coaxial Cable 75 ohm to the G.703 Network FromNetwork Signal PIN# Connecting the Twisted Pair 120 ohm to the G.703 NetworkConnecting the 10Base-T Ethernet port to a PC DTE 10Base-T Port 10Base-T DTE RJ-45 Pin No Connecting the 10Base-T Ethernet Port to a Hub10Base-T Port 10Base-T Hub RJ-45 Pin No +Vin Operation POWER-UPLED Status Monitors LED 703 NTU Model 2707/I Mbps G.703 Operating Line Loopback LLDevice Network Connector Appendix aNetwork Data Rate Nominal ImpedanceDiagnostics IndicatorsAppendix B DTE InterfacePower Supply TemperatureDimensions HumidityAppendix C Patton Model # DescriptionCopyright Patton Electronics Company All Rights Reserved