Patton electronic 2707/I Appendix B, DTE Interface, DTE Data Rates, LAN Connection, Protocol

Page 21

APPENDIX B

ETHERNET 10BASE-T SPECIFICATIONS

B.1 DTE INTERFACE

10Base-T on RJ-45F

B.2 DTE DATA RATES

10 Mbps

B.3 LAN CONNECTION

RJ-45, 10Base-T, 802.3 Ethernet

B.4 PROTOCOL

PPP (RFC 1661) with Bridging Control (RFC 1638)

B.5 MAC ADDRESS TABLE SIZE

4096 entries

B.6 MAC ADDRESS AGING

MAC addresses deleted after 8 minutes of inactivity

B.7 FRAME BUFFER

512 Frames

B.8 FRAME LATENCY

1 frame

B.9 DIAGNOSTICS

Line Loopback

B.10 INDICATORS

E-1 Link, 10Base-T Link, Ethernet Status, Test Mode

B.11 CONFIGURATION

8-Position DIP Switch

21

Image 21
Contents User Manual Configuration Warranty InformationInstallation SpecificationsFactory Replacement Parts and Accessories Service Warranty InformationRadio and TV Interference CE NoticePage Features General InformationDescription Applications PPP Operational BackgroundLAN Model 2707/I Model 2707/C Router Internet EthernetConfiguration DIP Switch ConfigurationsFront Rear Switch Description Setting Switch S1 settingsSW1-1 Line Coding HDB3 default SW1-1 Line EncodingPage Connecting to the G.703 Network and Ethernet LAN InstallationFrom Connecting Dual Coaxial Cable 75 ohm to the G.703 NetworkConnecting the Twisted Pair 120 ohm to the G.703 Network Network Signal PIN#Connecting the 10Base-T Ethernet port to a PC DTE Connecting the 10Base-T Ethernet Port to a Hub 10Base-T Port 10Base-T DTE RJ-45 Pin No10Base-T Port 10Base-T Hub RJ-45 Pin No +Vin POWER-UP OperationLED Status Monitors LED Operating Line Loopback LL 703 NTU Model 2707/I Mbps G.703Device Appendix a Network ConnectorNetwork Data Rate Nominal ImpedanceIndicators DiagnosticsAppendix B DTE InterfaceTemperature Power SupplyDimensions HumidityPatton Model # Description Appendix CCopyright Patton Electronics Company All Rights Reserved