Ethernet 
1
2
| USA |
in | the |
| |
Made |
|
Power
Line
Power
jack
CopperLINK
Dual 10/100
Ethernet ports
Figure 2. Model 2151 standalone rear panel
3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE
The Interconnecting cables shall be acceptable for
external use and shall be rated for the proper applica-
tion with respect to voltage, current, anticipated tem-
CAUTION perature, flammability, and mechanical serviceability.
The Model 2151 supports communication between two peer Ethernet LAN sites over a distance of up to 5,750 ft (1.7 km) over 24 AWG (0.5 mm)
Note Actual distance and link performance may vary depending on the environment and type/gauge of wire used.
Follow the steps below to connect the Model 2151 CopperLINK Inter- faces.
Note The Model 2151 units work in pairs. One of the units must be configured as a (L) Local unit, and the other unit must be config- ured as a (R) Remote unit.
10