Patton electronic 2172A user manual Configuring DIP Switch S1, Operation, Power UP

4.2 CONFIGURING DIP SWITCH S1

DIP switch S1 is where you configure the CopperLINK line. The following tables describe the configuration for the 2172A.

Table 1: 2172A Firmware Configuration

		S1-1		S1-2		S1-3		S1-4
Position
		Master/				Rate
		Slave
ON		Slave
		(CPE)		4/1, 15/2, 50/2, 10/10, 25/25, 50/50
OFF		Master		Rate Control (See table below).
		(CO)
	S1-2		S1-3		S1-4		Rate
							(DS/US)*
	OFF		OFF		OFF		4/1
	ON		OFF		OFF		15/2
	OFF		ON		OFF		50/2
	ON		ON		OFF		10/10
	OFF		OFF		ON		25/25
	ON		ON		ON		50/50

*. DS = Downstream, US = Upstream

5.0 OPERATION

Once the Model 2172As are properly installed, they should operate transparently. No user settings required. This section describes reading the LED status monitors.

5.1 POWER UP

Before applying power to the Model 2172A, please review section 3.3, “Connecting Power” on page 12 to verify that the unit is connected to the appropriate power source.

14