Patton electronic 2150 user manual Installation, Typical application

Page 9

Figure 1. Typical application

The pair of 2150 models work together to create a transparent extension between two peered Ethernet LANs. Figure 1 shows a typical point-to- point application.

3.0 INSTALLATION

The Interconnecting cables shall be acceptable for

external use and shall be rated for the proper applica-

tion with respect to voltage, current, anticipated tem-

CAUTION perature, flammability, and mechanical serviceability.

To install the 2150 Ethernet Extender, do the following:

1.Connect the line interface between the units (refer to section 3.1, “Connecting the Twisted-Pair Line Interface” on page 10)

Note See Figure 2 for the standalone unit’s rear panel arrangements.

2.Connect the Ethernet interface (refer to section 3.2, “Connecting the 10/100Base-T Ethernet Interface” on page 11).

3.Connect the power plug (refer to section 3.3, “Connecting Power” on page 12).

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents User Manual Contents Distance Chart, Based on 24 AWG 0.5 MM Low-Voltage Direcive Safety Warranty InformationRegulatory Information EMC DirectiveCE Declaration of Conformity ServiceAuthorized European Representative Tel +1 301 Email support@patton.com Must have an earth ground Safety When Working with ElectricityPage Features General InformationDescription Typical application InstallationModel 2150 standalone rear panel Connecting the TWISTED-PAIR Line InterfaceModel 2150 RJ-45 twisted pair line interface Connecting the 10/100BASE-T Ethernet InterfaceConnecting Power ConfigurationConfiguring the Hardware DIP Switches Front Rear Configuring DIP Switch S1 Power UPOperation Front Panel LED Status Monitors Power Supply LED Status IndicatorsTemperature Range DimensionsPatton Model # Description Appendix B10/100BASE-T Interface Appendix CRJ-45 Copperlink InterfaceSecond Appendix DCopyright Patton Electronics Company All Rights Reserved
Top Page Image Contents