1.3 SERVICE
All warranty and
Tel: | (301) |
Email: | http://www.patton.com |
www: | support@patton.com. |
NOTE: Packages received without an RMA number will not be accepted.
Patton Electronics’ technical staff is also available to answer any questions that might arise concerning the installation or use of your Model 2135. Technical Support hours: 8AM to 5PM EST, Monday through Friday.
WARNING! This device is not intended to be con- nected to the public telephone network.
2.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warrant- ed for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to con- tact Patton Electronics Technical Support at (301)
2.1FEATURES
-Integral V.35 Male to 10BaseT Ethernet
-Industry standard, shielded
-802.3 Ethernet supported by Transparent LAN bridging
-PPP Bridging Control Protocol (RFC 1638) with auto detection for compatibility with existing Patton Bridge Modules
-4096 MAC address table
-512 KB RAM; 128KB FLASH expandable to 512 KB
-Throughput latency of 1 frame
-Automatic LAN MAC address aging
-Nine LEDs monitor power, LAN, and DTE Interface signals
2.2DESCRIPTION
The Patton Model 2135 MicroBridge is an Ethernet Bridge that provides LAN extension when used in conjunction with a V.35 DCE device, such as a DSU/CSU, NTU, or router. The Model 2135 performs transparent Ethernet bridging and functions at the MAC level, thus is transparent to higher level protocols such as TCP/IP, DECnet, NET- BIOS, and IPX network protocols. Only broadcast, multicast, or frames set up for peered LAN are forwarded. The Model 2135 is 802.3 Ethernet compliant and supports PPP Bridging Control Protocol (RFC 1638) on the DTE side.
3 | 4 |