Connect the SmartNode to your PC | Patton electronic 4110 Series

2.0 Connect the SmartNode to your PC

Note For factory default IP address information, see Appendix A.0 on page 8.

Option 1: Connect to a network that has a DHCP server (SN4520 & SN4110). Using the included black Ethernet cable, connect the SmartNode RJ-45 Ethernet WAN port, labeled ETH0/0 (see ﬁgure 1), to an Ethernet hub or switch on the same network as your PC. WAN interface ETH0/0 is conﬁgured as DHCP client.

SmartNode

DHCP

Server

	ETHO/O	ETH 0/0
PC	Ethernet Hub
	or Switch

Voice Ports

0/3 0/2 0/1 0/0

FXS

Figure 1. Connecting the SmartNode to your PC through a hub or switch

SmartNode

4520

ETH	0/0

ETHO/1

ETH	0/1

Voice Ports

0/3 0/2 0/1 0/0

FXS

Figure 2. Connecting the SmartNode directly to your PC

Option 2: Connect directly to a PC (SN4520 only).

LAN interface ETH0/1 is conﬁgured as DHCP server (see ﬁgure 2).

1.Conﬁgure your PC as a DHCP client.

Note The procedures below are for Microsoft Windows. For another operating system, refer to the operating instruction that came with your PC.

SmartNode 4520 and 4110 Quick Start Guide