Access the Command Line Interface | Patton electronic 4110 Series

4.0Access the Command Line Interface

1.In the Discovery Tool window, select the IP address of your SmartNode.

2.Right-click the selected line, and select Telnet.

3.In the telnet window, enter the username administrator. At the password prompt simply press the enter key. The SmartNode will respond by display- ing its IP address as the command line prompt.

4.After you log in your SmartNode will be running in operator execution mode (indicated by > character in the command line prompt). To enter con- ﬁguration mode, use the commands enable and conﬁgure.

10.10.22.50>enable 10.10.22.50#configure 10.10.22.50(cfg)#

You may now start to conﬁgure the SmartNode from scratch using the CLI com- mands, but we recommend that you start your conﬁguration from a template. See section 5.0 “Download a conﬁguration example, adapt it to your network, and load it onto the SmartNode” on page 7 for further details.

For a detailed description of the CLI refer to the SmartWare Software Conﬁgura- tion Guide (SCG) available on the CD-ROM and online at www.patton.com/voip.

6	SmartNode 4520 and 4110 Quick Start Guide