TP-Link manual Network, TL-WN7200N 150Mbps High Power Wireless USB Adapter User Guide

Page 18

3.1.2 Network

TL-WN7200N150Mbps High Power Wireless USB Adapter User Guide

Figure 3-4 Edit a Profile-Auth.\Encry.

¾Authentication – You can choose the Authentication Type from the pull-down list with three options, Open System, Shared-Key System or LEAP.

¾802.1x – It enables when Authentication Type is setting to WPA.

¾Encryption – Displays which encryption type that the driver is using. When you select Open System, Shared-Key System as Network Authentication, there are two options: WEP and Disabled. If you select WPA-PSKas Network Authentication, there are TKIP and AES options instead of WEP and Disabled.

¾Wep Key – Key #1, Key #2, Key #3, Key #4, the Key groups. You can enter 10 hexadecimal digits (any combination of 0-9, a-f, A-F) or 5 ASCII characters for 64-bit (also called 40bits) encryption. You can enter 26 hexadecimal digits (any combination of 0-9, a-f, A-F) or 13 ASCII characters for 128-bit (also called 104bits) encryption.

3.To delete a profile: Highlight the desired profile name on Profile List, and click the Delete button.

4.To switch to another profile: Highlight the desired profile name on Profile List, and click the Activate button.

3.1.2 Network

Click the Network tab of the Utility and the Network screen with many available wireless network

- 13 -

Image 18

Contents TL-WN7200N 150Mbps High Power Wireless USB Adapter Rev 1910010295COPYRIGHT & TRADEMARKS FCC STATEMENTCE Mark Warning FCC RF Radiation Exposure StatementNational restrictions DECLARATION OF CONFORMITY CONTENTS Package Contents 150Mbps High Power Wireless USB Adapter User GuideTL-WN7200N 1.1 Product Overview 1.2 Main FeaturesChapter 1 Introduction TL-WN7200N 150Mbps High Power Wireless USB Adapter User Guide1.3 LED Status Chapter 2 Installation Guide 2.1 Hardware Installation2.2 Software Installation Figure 2-1 Preparing Setup Figure 2-2 Setup Type3. As next screen, you can select the configuration tool here Figure 2-3 Setup Type Figure 2-5 Ready to Install the Program Figure 2-8 InstallShield Wizard Complete Figure 2-7 Windows XP Warning Box2.3 Uninstall Software 2.3.1 Uninstall the driver software from your PC2.3.2 Uninstall the utility software from your PC Chapter 3 Configuration 3.1 Configuration of UtilityFigure 3-1 Profile Tab ¾ System Config Here you can change the Profile Name and SSID 3.1.2 Network 3.1.3 Advanced 3.1.4 Statistics 3.1.5 QSSI. PBC Method II. PIN MethodNoteQSS 3.1.6 Radio On/Off 3.1.7 About3.1.8 An example for application 3.2 Configure with Windows XP Wireless Zero Configuration Figure 3-15 Acquiring network address Figure 3-16 Finish4.1 Config Chapter 4 AP Mode4.2 Access Control 4.3 Mac Table 4.4 Event Log 4.5 Statistics Figure 4-6 Event Log Page¾ Message - Displays all event messages 4.6 About Figure 4-7 Transmit and Receive statisticsFigure 4-8 About Page 5.1 Configuration of PSP XLink Online game Chapter 5 Example for ApplicationStep 6. Click Start Control Panel Network 150Mbps High Power Wireless USB Adapter User Guide 5-7 shown Click the icon first and then click the folder TL-WN7200N 150Mbps High Power Wireless USB Adapter User Guide Appendix A Glossary Spectrum FHSS TL-WN7200N 150Mbps High Power Wireless USB Adapter User Guide Wireless SpecificationsAppendix B General