TP-Link TR-966D manual Network Cable Supported, Appearance Indication, Front Panel, Rear Panel

Auto-detection of half/full duplex transfer mode for RJ45 port.

Auto-negotiation of 10/100Mbps rate and Auto-MDIX for

RJ45 port.

Fiber port only support full duplex transfer.

Extend fiber distance up to 20km for fiber port.

Easy-to-view LED indicators provide status to easily monitor network activity.

External power supply.

Network Cable Supported

The connectors and network cables supported by the TR-966D are listed in the following:

RJ45 port: Cat 5 Twisted-pair

SC Fiber port: single-mode fiber cable

Appearance Indication

1. Front Panel

The front panel of the TR-966D consists of several LED indicators

	POWER	_LINK/ACT_LINK/ACT_LINK/ACT_SPD				_LINK/ACT_SPD
TR-966D		F2	F1	T2	T2	T1	T1

10/100M WDM Fiber Bridge

TR-966D Front Panel

2. Rear Panel

The rear panel of the TR-966D consists of one AC power connector, two 10/100Mbps RJ45 ports and two SC Fiber interfaces.

POWER T1 T2 F1 F2

TR-966D Rear Panel

3. LED Indicators

This TR-966D has LED indicators which can provide a real- time report. When you take a look at these indicators, you will know what’s happening your network.

Power(Red): Lights when the adapter is properly plugged in.

T1_SPD/T2_SPD(Green): Light when the RJ45 port is connected to 100Mbps device; When the port connect to a 10Mbps device, the LED turns off.