TP-Link TR-966D manual Installation Guide, Configuration, Installation procedure

T1_Link/ Act/ T2_Link/ Act(Green): Steady green indicates that a valid link exists. Flashing green indicates that the TR-966D is receiving or transmitting data from the

RJ-45 port.

F1_Link/Act/ F2_Link/Act (Green): Steady green indicates that a valid link exists. Flashing green indicates that the TR-966D is receiving or transmitting data from the fiber port.

Installation Guide

1. Configuration

In order to achieve the aim of effectively expanding a Fast Ethernet network, you can use the TR-966D as the example.

2. Installation procedure:

A.Connect the TR-966D to 10/100Base-TX Device (Hub or Switch).

Make sure that the length of twisted pair cable (Category-

5)between 10/100Base-TX device and converter is not longer than 100 meters.

Connect one end of twisted pair cable to RJ45 jack on the

TR-966D and the other end of the cable to the cable to the RJ-45 jack on the 10/100Base-TX device.

B. Connect the TR-966D to 100Base-FX Device Connection.

Connect on (SC) end of a singl-mode fiber cable to the SC connector F1/F2 on the TR-966D and the other end of the cable to 100Base-FX device.

C.Turn on the device.

Notes:

The WDM technology employs passive optic multiplexing, thus multiplex the transmit (TX) and receive (RX) lines onto a single fiber. WDM technology is implemented in couples. For example, one site uses the F1 fiber port on the TR-966D, the other site uses DEVICE A, the fiber port on DEVICE A must be 1550nm/1310nm WDM fiber; One site uses the F2 fiber port on the TR-966D, the other site uses DEVICE B, the fiber port on DEVICE B must be 1310nm/1550nm WDM fiber.