TP-Link TL-WR740N manual Quick Setup Wireless

TL-WR740N

Wireless Lite N Router

Figure 3-9 Quick Setup – Wireless

¾Wireless Radio - Enable or disable the wireless radio choosing from the pull-down list.

¾SSID - Enter a value of up to 32 characters. The same name of SSID (Service Set Identification) must be assigned to all wireless devices in your network. Considering your wireless network security, the default SSID is set to be TP-LINK_xxxxxx (xxxxxx indicates the last unique six numbers of each Router’s MAC address). This value is case-sensitive. For example, TP-LINKis NOT the same as tp-link.

¾Region - Select your region from the pull-down list. This field specifies the region where the wireless function of the Router can be used. It may be illegal to use the wireless function of the Router in a region other than one of those specified in this field. If your country or region is not listed, please contact your local government agency for assistance.

¾Channel - This field determines which operating frequency will be used. The default channel is set to 6. It is not necessary to change the wireless channel unless you notice interference problems with another nearby access point.

¾Mode - This field determines the wireless mode which the Router works on.

¾Channel Width - Select any channel width from the pull-down list. The default setting is automatic, which can adjust the channel width for your clients automatically.

¾Max Tx Rate - You can limit the maximum transmission rate of the Router through this field.

- 13 -