TP-Link TL-WR740N manual FCC RF Radiation Exposure Statement, Country Restriction Reason/remark

Page 3

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

National restrictions

This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below:

Country

Restriction

Reason/remark

 

 

 

Bulgaria

None

General authorization required for outdoor use and

public service

 

 

 

 

 

Outdoor use limited to 10

FrancemW e.i.r.p. within the band 2454-2483.5 MHz

Military Radiolocation use. Refarming of the 2.4 GHz band has been ongoing in recent years to allow current relaxed regulation. Full implementation planned 2012

Italy

None

If used outside of own premises, general authorization is

required

 

 

 

 

 

Luxembourg

None

General authorization required for network and service

supply(not for spectrum)

 

 

 

 

 

Norway

Implemented

This subsection does not apply for the geographical area

within a radius of 20 km from the centre of Ny-Ålesund

 

 

 

 

 

Russian Federation

None

Only for indoor applications

 

 

 

Note: Please don’t use the product outdoors in France.

- II -

Image 3
Contents TL-WR740N Copyright & Trademarks FCC Statement Country Restriction Reason/remark FCC RF Radiation Exposure StatementZhao Jianjun Director of International Business Product Description Wireless Lite N RouterContents Dhcp 100 Package Contents Incredible Speed Flexible Access ControlSimple Installation Overview of the RouterFront Panel Main FeaturesConventions Panel LayoutWlan Name Status IndicationRear Panel ¾ RESET:Installation Environment Requirements Connecting the RouterSystem Requirements TL-WR740N TCP/IP Configuration Quick Installation GuidePlease check the connection following these steps Success result of Ping commandLogin Windows Quick Installation GuideQuick Setup Quick Setup Static IP Quick Setup Wireless 10 Quick Setup Finish Status LoginRouter Status Quick Setup QSSBy PBC Method Two Method OneMethod Three Add a New Device Next II. By PINTL-WR740N 1 LAN NetworkLAN 2 WANTL-WR740N TL-WR740N WAN PPPoE TL-WR740N 10 PPPoE Advanced Settings NSW / ACT nsw.bigpond.net.au TL-WR740N 12 WAN L2TP TL-WR740N 13 Pptp Settings MAC Clone Wireless Settings Wireless16 Wireless Settings Wireless Security 17 Wireless Security 19 WPA/WPA2 Encryption You can select either Automatic, or Tkip or AESTL-WR740NWireless Lite N Router Wireless MAC Filtering21 Wireless MAC Filtering To modify or delete an existing entry Wireless Advanced 24 Wireless Statistics Wireless StatisticsDhcp Dhcp Settings27 Dhcp Clients List Dhcp Clients ListTo Reserve an IP address Address ReservationVirtual Servers Forwarding32 Add or Modify a Virtual Server Entry To setup a virtual server entryPort Triggering 34 Add or Modify a Port Triggering Entry To add a new rule, follow the steps below3 DMZ UPnPTo assign a computer or server to be a DMZ server Basic Security SecurityAs shown in Figure Advanced Security Local Management 40 Local Management Remote Management41 Remote Management Parental ControlTo add a new entry, please follow the steps below 42 Parental Control Settings43 Add or Modify Parental Control Entry Rule 11Access ControlTo add a new rule, please follow the steps below 46 Access Control Rule Management47 Add or Modify Internet Access Control Entry Host 48 Host Settings49 Add or Modify a Host Entry Target 51 Target Settings52 Add or Modify an Access Target Entry Schedule 54 Schedule SettingsTo add a new schedule, follow the steps below 55 Advanced Schedule SettingsTo add static routing entries, follow the steps below Static RoutingBandwidth Control Control SettingsRules List 59 Bandwidth Control SettingsBinding Settings 14IP& MAC Bing SettingTo find an existing entry, follow the steps below To add IP & MAC Binding entries, follow the steps below65 Find IP & MAC Binding Entry ARP ListComexe.cn Ddns Dynamic DNSDyndns.org Ddns To set up for DDNS, follow these instructions68 Dyndns.org Ddns Settings 70 The System Tools menu System ToolsTime Settings To configure the system manuallyTo configure the system automatically Diagnostic 73 Diagnostic Results Firmware Upgrade75 Restore Factory Default Factory DefaultsReboot Backup & RestoreSystem log Password79 System Log TL-WR740N 81 Statistics StatisticsBytes Statistics Table IP/MAC AddressPackets TotalAppendix a FAQ Want to use NetMeeting, what do I need to do? Figure A-3 MAC CloneFigure A-5 Add or Modify a Virtual server Entry Want to build a WEB Server on the LAN, what should I do? Figure A-7 Basic SecurityFigure A-9 Virtual Servers Wireless stations cannot connect to the RouterConfigure TCP/IP component Appendix B Configuring the PCShown in the Figure below ¾ Setting IP address manually Now Wireless GeneralEnvironmental and Physical Appendix D Glossary 102