¾Start IP Address - This field specifies the first address in the IP Address pool. 192.168.0.100 is the default start IP address.
¾End IP Address - This field specifies the last address in the IP Address pool. 192.168.0.199 is the default end IP address.
¾Address Lease Time - Enter the amount of time for the PC to connect to the Range Extender with its current assigned dynamic IP address. The time is measured in minutes. After the time is up, the PC will be automatically assigned a new dynamic IP address. The range of the time is 1 ~ 2880 minutes. The default value is 120 minutes.
¾Default Gateway (optional) - Enter the IP address of the gateway for your LAN. The factory default setting is 0.0.0.0.
¾Default Domain (optional) - Enter the domain name of the your DHCP server. You can leave the field blank.
¾Primary DNS (optional) - Enter the DNS IP address provided by your ISP. Consult your ISP if you don’t know the DNS value. The factory default setting is 0.0.0.0.
¾Secondary DNS (optional) - Enter the IP address of another DNS server if your ISP provides two DNS servers. The factory default setting is 0.0.0.0.
Click Save to save the changes.
)Note:
To use the DHCP server function of the device, you should configure all computers in the LAN as "Obtain an IP Address automatically" mode. This function will not take effect until the device reboots.
4.4.3 DHCP Client List
Selecting Network > DHCP Client List will enable you to view the Client Name, MAC Address, Assigned IP and Lease Time for each DHCP Client attached to the device (Figure 4
Figure 4-11 DHCP Clients List
¾ID - Here displays the index of the DHCP client.
¾Client Name - Here displays the name of the DHCP client.
¾MAC Address - Here displays the MAC address of the DHCP client.
¾Assigned IP - Here displays the IP address that the Range Extender has allocated to the DHCP client.
¾Lease Time - Here displays the time of the DHCP client leased. Before the time is up, DHCP client will request to renew the lease automatically.
You cannot change any of the values on this page. To update this page and to show the current attached devices, click on the Refresh button.
16