Polycom RMX 1000 V1.1.1, SE 200 V3.0.2/CMA manual Manage Device, Add Device

Page 7

2

Manage Device

Add Device

1Click Device Admin/Monitor View, See the following drawing:

2Click Add Device listed in Commands Device Navigation, there will pop-upAdd New Device page.

Set information as follows:

a.Select Device Type to RMX,

b.Set IP Address to a valid IP of RMX 1000 device,

c.Set Admin ID to a valid username of the RMX 1000 device,

d.Set Password to a valid password of the RMX 1000 device, See the following drawing:

2-1

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Page Catalog No Version Table of Contents Page Introduction Page Add Device Manage DeviceManage Device View Device status Delete Device Edit Device detailCreate a template Schedule conferenceCreate a conference Set MCU Settings Set Supported MCUs RMX to SelectedClick Schedule Page Manage conference Extend Conference Change LayoutAdd participant Manage participantManage conference Connect/Disconnect Participant Remove Participant Mute/unmute Participant Manage conference Terminate conference
Top Page Image Contents