TP-Link manual Port Triggering, TL-R402M Cable/DSL Router User Guide

TL-R402MCable/DSL Router User Guide

To setup a virtual server entry:

1.Select the service you want to use from the Common Service Port list, select the ID you want to use, and click the Copy to button. If the Common Service Port list does not have the service that you want to use, type the number of the service port or service port range in the Service Port box.

2.Type the IP address of the computer in the Server IP Address box.

3.Select the protocol used for this application, either TCP,UDP, or All.

4.Select the Enable checkbox to enable the virtual server.

5.Click the Save button.

Note:

It is possible that you have a computer or server that has more than one type of available service. If so, select another service, and enter the same IP address for that computer or server.

To modify a virtual server entry:

1.Select the entry you want to modify

2.Modify the information from the Service Port, the IP Address boxes, and the Protocol pull-down list.

3.Click the Save button.

To delete a service entry:

1.Clear the entry's all information except for the Protocol pull-down list.

2.Click the Save button.

To delete all service entries:

1.Click the Clear All button.

2.Click the Save button.

3.3.Click the Next button to go to the next page and Click the Previous button to return the previous page.

Note:

If you set the virtual server of the service port as 80, you must set the web management port on Security –> Remote Management page to be any value except 80 such as 8080. Or else there will be a conflict to disable the virtual server.

5.6.2 Port Triggering

Some applications require multiple connections, like Internet games, video conferencing, Internet calling and so on. These applications cannot work with a pure NAT router. Port Triggering is used for some of these applications that can work with an NAT router. You can set up Port Triggering on this page shown in Figure 5-16:

26