TP-Link TL-R480T+ manual Load Balance Broadband Router User Guide

TL-R480T+

Load Balance Broadband Router User Guide

¾Domain Name - This is the domain or key word as desired. Leaving the field blank means all websites on the Internet are prohibited from accessing.

¾Status - This field displays the status, Enabled means the rule is effective, Disabled means the rule is ineffective.

To add or modify a Domain Filtering entry:

For example: if you want to block the PCs on your LAN from accessing websites www.xxyy.com.cn, www.aabbcc.com and websites with end of .net on the Internet, while no limit for other websites, you can configure as follows.

Step 1: Enable the “Firewall” and “Domain Filtering” on the Firewall screen (show in Figure 4-31).

Step 2: Select the Deny to access websites specified by rules as the Default Domain Filtering Rules on the Firewall screen (show in Figure 4-31).

Step 3: Click Add New…/Modify shown in Figure 4-35,you will see a new screen shown in Figure 4-36.

Step 4: Enter the “Effective time” that the rule will take effect, enter the “Domain Name” as shown in Figure 4-36.

Step 5: Select the “Status” for the rule as shown in the next screen.

Figure 4-36

Step 6: Finally, click Save to make the rule take effect.

Step 7: Go to Step 2 to complete the other rules continually.

After you finish the configurations, you will see the rules in the table below:

Figure 4-37

)Note:

Before adding an IP Address Filtering entry, you should enable the Firewall and the IP Address Filtering function first (shown in Figure 4-31).

Other configurations for the entries as shown in Figure 4-32:

51