3.3The Back Panel
The Router's ports, where the cables are connected, and RESET button are located on the back panel.
Figure
¾Antenna: Used for wireless operation and data transmit.
¾Power: The Power plug is where you will connect the power adapter.
¾LAN 1,2,3,4: Four 10/100Mbps RJ45 LAN ports for connecting the router to the local PC(s)
¾Reset Button:
There are two ways to reset the Router's factory defaults:
1)Press the reset button of the Router, and then power on the Router, hold reset button pressed down for about five seconds,
2)Restore the default setting from “Management - Settings - Restore Default “of the Router's
¾Line: Connect to the Modem Port of Splitter or to the telephone line.
¾Wireless antenna
3.4System Requirements
¾Make sure your computer has a Networking Interface Card (either wired or wireless is ok) before connecting the Router to your computer.
¾An operating system supporting the TCP/IP protocol.
¾Broadband Internet Access (ADSL).
¾Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later.
6