ZyXEL Communications 100WH quick start Windows NT Quick Start, TCP/IP Installation

Page 19

Prestige 100WH Quick Start Guide

Chapter 4

Windows NT Quick Start

This chapter shows you the step-by-step instructions to configure your Windows NT workstations for Internet access.

4.1TCP/IP Installation

You must first install TCP/IP protocol on each Windows NT workstation before you can use it to access the Internet. If you have already installed TCP/IP, skip to the TCP/IP Configuration section on page 15; otherwise, follow these steps:

Step 1. From the Start Menu, select Settings then open Control Panel.

Step 2. Double-click the Network icon to open the Network control panel.

Step 3. Select the Protocols tab, then click the Add… button.

15

Page 18 Page 20
Image 19
Page 18 Page 20
Contents ZyXEL Prestige 100WH Table of Contents Prestige Web Configurator Setup Purpose Of This Guide Before You BeginWho Should Not Use This Guide Information From Your ISP Dhcp Setting Prestige’s Default TCP/IP SettingsIP Address and Subnet Mask Page Prestige 100WH Front Panel Cabling & InstallationFront Panel Description LED Front Panel LedsWAN Port Status LEDs Prestige 100WH Back PanelPrestige 100WH Connections PSTN/ISDNWindows 95 Quick Start TCP/IP InstallationThis will install the TCP/IP protocol on your workstation TCP/IP Configuration Prestige 100WH Quick Start Guide Prestige 100WH Quick Start Guide Prestige 100WH Quick Start Guide Windows NT Quick Start This will install the TCP/IP protocol on you workstation TCP/IP Configuration Prestige 100WH Quick Start Guide Prestige 100WH Quick Start Guide Prestige 100WH Quick Start Guide Installing PWC Components Prestige Web Configurator SetupPrestige 100WH Quick Start Guide Prestige 100WH Quick Start Guide Starting the Prestige Web Configurator Contacting ZyXEL Customer Support ZyXEL Prestige 100WH
Related manuals
Manual 126 pages 31.02 Kb
Top Page Image Contents