ZyXEL Communications 3356P-LAN user manual Hardware, Non-Windows 95 & Windows NT Operating Systems

Page 9

2 Installation

This chapter describes how to install your Comet hardware. Installation procedures also cover Windows 3.x, Windows 95, Windows NT 4.0, and DOS operating systems.

Hardware

You can insert your Comet with your computer turned on or off. Follow the steps below to complete the hardware installation:

1.Hold the card label up and insert the card into the computer's PCMCIA slot with the 68 pin connector facing the computer.

2.Plug the 15-pin PC Card connector with both RJ-45 LAN cord and RJ-11 telephone cord into the 15-pin socket on the PC Card. Now the hardware installation is completed. The PC Card is powered directly by the PC.

3.Connect the RJ-45 (8-pin) plug to the LAN and the RJ-11 (6-pin) plug to the telephone wall outlet.

Non-Windows 95 & Windows NT Operating Systems

Novell Netware Installation

Follow the steps bellow to complete Novell Netware installation:

1.Insert the driver diskette into the floppy drive and set to the appropriate drive (A:\). Then type INSTALL and press Enter.

2.Select Netware 3.x and 4.x Workstation from the installation program dialog box.

3.Check the card settings. If current settings are correct, select Start Installation and go to step 5. Otherwise, select Modify Parameters to change settings.

4. Select the appropriate values then press Enter. When you are finished, press OK to exit.

Installation 3

Image 9

Contents Comet 3356P-LAN User’ s Manual Limited Warranty AcknowledgmentsFCC Part 15 Information Contacting ZyXEL FCC Requirements∙ E-mail Table of Contents Status Registers & Result Codes Unpacking Your Modem Hardware OverviewRequired Equipment Introduction Novell Netware Installation HardwareNon-Windows 95 & Windows NT Operating Systems MS LAN Manager Installation Bindings = Lmndisnif Lanabase = Windows for Workgroups 3.11 Installation Packet Driver InstallationSelect Enhanced mode NDIS3 for.... then press OK Windows NT 3.51 InstallationEthernet + Fax/Modem PC Card Installation for NT Choose Program Manager, Main, Control Panel, NetworkWindows NT4.0 Installation Select Ethernet + Fax/Modem PC then click OKResource Recommendations Choose My computer, Control Panel, Network, Adapters Choose My computer, Control Panel, NetworkArtisoft Lantastic 6.0 Installation Windows 95 InstallationPage Installation Using the Windows 95 Hyper Terminal Program Understanding AT CommandsDialing and Answering Techniques Dialing using the ATD CommandQuick Tips when issuing AT Commands Making Your First ConnectionAuto-Answer and Hook Controls AT Command Set/Type Example Command DescriptionModem Result Codes Non-Volatile MemoryViewing S Register Values Changing S Register ValuesDefault Modem Settings for PC’ s Saving Settings and User ProfilesCommand Dialing Stored Phone NumbersCommand Use both V.42bis and MNP 5 data compression Basic Modem Operation Basic AT Command Set AT Command Set SummariesSpeaker always on Extended AT& Command Set Extended AT% Command Set Extended AT\ Command SetExtended AT- Command Set AT Command Set Summaries Status Registers & Result Codes Register Dec Function & Description Default Result Code Options Table Extended Result Code Options Table Connect Connect 300 EC NoEC