8.Insert the driver disk into floppy disk drive, then enter the correct path (A:\).
9.Select Ethernet + Fax/Modem PC then click OK.
10.Set the appropriate system resources for the Ethernet + Fax/Modem PC Card. Make sure the settings you choose do not conflict with any other devices.
Resource Recommendations
I/O Base | I/O:300. Possible alternative: 320, 340, 360 |
|
|
Interrupt | IRQ:5. If your laptop is equipped with multimedia devices, a |
(IRQ) | higher interrupt (IRQ:11) may be needed. |
|
|
Base Memory | D000. Possible alternative: D800 |
|
|
COM Port | COM2 to COM4. Select one of the COM port that is not in |
| use by other communication devices. |
|
|
11. When all settings are completed, press OK.
Windows NT will load network and grant configurations for:
-TCP/IP
Typically configurations for each network are unique. Ask your network administrator for help if you want to change them.
12.Once all network software is loaded, press OK. The configuration and bindings for the PC Card might ask for confirmation. Answer any questions accordingly.
13.Connect to your network using the provide 10BaseT cord with
14.Reboot the system.
Windows NT4.0 Installation
1.Remove all existing PC Cards from the system.
2.Run Windows NT 4.0
3.Login with a full access level i.e. ADMINISTRATOR.
4.Choose My computer, Control Panel, Network, Adapters and remove all existing network components.
5.Click CLOSE after all network components have been removed.
8 Installation