Kramer Electronics VP-721DS, VP-722DS Exclusion of Damages, Compliance Notice, EN-50081, CFR-47

Page 13

EXCLUSION OF DAMAGES

Kramer’s liability for any defective products is limited to the repair or replacement of the product at our option. Kramer shall not be liable for:

1.Damage to other property caused by defects in this product, damages based upon inconvenience, loss of use of the product, loss of time, commercial loss; or:

2.Any other damages, whether incidental, consequential or otherwise. Some countries may not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations and exclusions may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from place to place.

Note - All products returned to Kramer for service must have prior approval. This may be obtained from your dealer.

14COMPLIANCE NOTICE

This equipment has been tested to determine compliance with the requirements of:

EN 55022

CE emissions standards, Class B

EN-50081

Generic Immunity standard for residential, commercial and light industrial)

CFR-47

FCC Rules and Regulations:

 

Part 15- Radio frequency devices:

Subpart B - Unintentional radiators

CAUTION!

Servicing the Video Scaler can only be done by an authorized Kramer technician. Any user who makes changes or modifications to the unit without the expressed approval of the manufacturer will void user authority to operate the equipment.

Please use recommended interconnect cables to connect the machine to other components.

When used, it is assumed that the unit is grounded by normal means (e.g. via the computer video input cable, rack-mount chassis ground, or video output cable to display device). Use of the equipment without any form of grounding may affect radiated emissions, but will not affect the product's safety.

Kramer Electronics Ltd.

13

Image 13
Contents Video Scalers Table Of Contents Word about Video Scalers IntroductionFactors Affecting Quality of Results Video Adjustments SpecificationsConnecting the Hardware Unpacking and ContentsHOW do I GET STARTED? Connecting the Video Output Connecting the Video InputsConnecting the Serial Cable Connecting the AC PowerInput Selecton About the Video ScalerAuto Button Input ButtonOutput Selection Video Signal AdjustmentOutput Button Select, + and ButtonsGND DSR RTS CTS 10 RS-232 Control of the VP-722DS Video Scaler11.1 HD15 Connector Information Technical DataFuse Replacement Troubleshooting HOW Long is the Warranty Limited WarrantyWhat is Covered and What is not Covered HOW YOU can GET Warranty ServiceCompliance Notice Exclusion of DamagesEN-50081 CFR-47