IOGear M0560, GIC704SR5W6 manual Creating Mirrored Sets RAID, Select Auto conﬁguration. Press Enter

Page 14

Creating Mirrored Sets (RAID 1)

1.As the BIOS boots, Press CTRL+S or F4 to enter the RAID bios utility.

2.Select Create RAID set. Press Enter.

3.Select RAID 1 then press Enter.

4.Select Auto conﬁguration. Press Enter.

5.Press Y to save your settings.

6.Press CTRL+E and then press Y to exit the setup.

7.Continue with conventional Fdisk and Format steps to prepare the hard drives.

8.Your RAID hardware conﬁguration is complete. Proceed to software installation section.

14

Image 14

Contents Installation Guide Page Table of Contents Page Introduction High Speed Serial ATA Interface FeaturesPCI Interface Package Contents Disk Striping RAID What Is RAID?RAID Redundant Array of Independent Disks Disk Mirroring RAIDMirrored-Striping RAID 0+1 also known as RAID Parity RAID RAIDJust a Bunch of Disks JBOD/Contiguous Installation Procedure Use the SATARAID5 Manager GUI to conﬁgure your RAID settings Select Create RAID set. Press Enter Bios RAID SettingsCreating Striped Sets RAID Select the Number of hard drives. Press EnterCreating Mirrored Sets RAID Select Auto conﬁguration. Press EnterCreating Parity RAID RAID Creating a Mirrored-Striped Set RAIDSelect Create RAID set. Press F2 Select Spare Drives. Press Enter Creating Jbod SetsCreating Spare Drive Rebuilding Mirrored Sets RAID Deleting RAID SetsSelect Delete RAID set. Press Enter Software Installation Windows XP Fresh InstallationWindows XP Existing Installation Page Verifying controller installation Federal Communications Commission FCC Statement Page CE Statement Limited Warranty Contact Toll Free 866 9-IOGEAR Phone 949 453-8782 23 HubblePage FUN