IOGear GIC704SR5W6, M0560 manual

Page 23

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:

1.this device may not cause interference and

2.this device must accept any interference, including interference that may cause undesired operation of the device.

FCC RF Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

23

Image 23
Contents Installation Guide Page Table of Contents Page Introduction High Speed Serial ATA Interface FeaturesPCI Interface Package Contents Disk Mirroring RAID What Is RAID?RAID Redundant Array of Independent Disks Disk Striping RAIDParity RAID RAID Mirrored-Striping RAID 0+1 also known as RAIDJust a Bunch of Disks JBOD/Contiguous Installation Procedure Use the SATARAID5 Manager GUI to configure your RAID settings Select the Number of hard drives. Press Enter Bios RAID SettingsCreating Striped Sets RAID Select Create RAID set. Press EnterSelect Auto configuration. Press Enter Creating Mirrored Sets RAIDCreating Parity RAID RAID Creating a Mirrored-Striped Set RAIDSelect Create RAID set. Press F2 Select Spare Drives. Press Enter Creating Jbod SetsCreating Spare Drive Rebuilding Mirrored Sets RAID Deleting RAID SetsSelect Delete RAID set. Press Enter Windows XP Fresh Installation Software InstallationWindows XP Existing Installation Page Verifying controller installation Federal Communications Commission FCC Statement Page CE Statement Limited Warranty Toll Free 866 9-IOGEAR Phone 949 453-8782 23 Hubble ContactPage FUN