IOGear GCS1712 user manual Factory Default Settings See Table Below, SET Password

Operation

Setting	Function
	This function allows you to set a password in order to control console access.
	1. Move the highlight bar to: Password, then press [Enter]. You are presented with a screen that
	allows you to key in your password. The password may be up to 8 characters long, and can consist
	of any combination of letters and numbers (A - Z, 0 - 9).
SET PASSWORD	2. Key in the new password, then press [Enter]. You are asked to key the password in again in
	order to confirm that it is correct.
	3. Key in the new password again, then press [Enter]. If the two entries match, the new password
	is accepted. If the entries do not match, you must start again from the beginning. To modify or
	delete a previous password, use the backspace key to erase individual letters or numbers.
SET SCAN DURATION	Determines how long the display dwells on each port as it cycles through the selected ports in Auto
	Scan Mode. The options are: 3, 5, 10, 15, 20, 30, 40, and 60 seconds.
	Selects which Hotkey activates the OSD function: [Ctrl] [Ctrl] or [Scroll Lock][Scroll Lock]. The
SET OSD ACTIVATING HOTKEY	default is the Ctrl key combination, but this may conflict with programs running on the computers, in
	which case, the scroll Lock option should be used.

Factory Default Settings: (See Table Below)

Setting	Default
Display Duration	Always On

Display Mode

The Port Number plus the Port Name

Scan Duration

5 Seconds

19