IOGear GUWH104KIT manual Software Installation, Important Note

Page 12

Software Installation

Please always check www.iogear.com for the latest drivers.

IMPORTANT NOTE:

If your PC already has a version of this software installed, please be sure to un-install it before proceeding.

Use Control Panel -> Add or Remove Programs. Scroll to “Ultrasuite with WiCenter Basic.” Click “Ultrasuite with WiCenter Basic,” then click Remove.

Restart your PC after the software has successfully un-installed.

You may now proceed with the installaion of new software.

If installing on Windows XP, Service Pack 2 (SP2) is required. Verify that this has been installed before installing the UWB software.

1.To install the UWB software, insert the included CD into your computer. The following menu should appear automatically. If not, select “Run CD_Start.exe” OR navigate to the CD Rom drive containing the installation CD and double- click on CD_Start.exe to bring up the user menu. Click on Software Installation to begin the installation process.

12

Image 12
Contents Installation Guide Page Welcome Table of Contents Introduction Features Requirements Package Contents Active Host LEDs Switch Power LED Device OverviewInstallation Hardware Preparation Software Installation Important NotePage Page Page Page After the software has fully installed, restart the PC Driver Installation Step Step Step Page Page Page Advanced Settings Page Page Frequently Asked Questions Problem Host LED blinking on the Wireless USB Hub Page Page Technical Support Page Limited Warranty Federal Communications Commission FCC Statement Contact IOGEAR, INCPage FUN