IOGear GUWH104KIT manual

Page 22

The below window will pair the Wireless USB Hub to your PC. Select Automatic wireless reconnection (Recommended) and select Next.

You should now see the wizard indicating that the association was successful.

Once the association is successful and the Active HOST LED has stopped flashing on the Wireless USB Hub, unplug the USB cable from the Wireless USB Hub in order to establish the wireless link. Click Next to continue.

22

Image 22
Contents Installation Guide Page Welcome Table of Contents Introduction Features Requirements Package Contents Active Host LEDs Switch Power LED Device OverviewInstallation Hardware Preparation Software Installation Important NotePage Page Page Page After the software has fully installed, restart the PC Driver Installation Step Step Step Page Page Page Advanced Settings Page Page Frequently Asked Questions Problem Host LED blinking on the Wireless USB Hub Page Page Technical Support Page Limited Warranty Federal Communications Commission FCC Statement Contact IOGEAR, INCPage FUN