Chapter 3
Advanced Configuration
The Wireless Tab > Basic
This screen allows you to change the PrintServer’s basic wireless settings.
Wireless > Basic
Configuration
Regulatory Domain and MAC Address The PrintServer’s Regulatory Domain and MAC Address are listed and cannot be changed.
SSID Enter the name of your wireless network. This is the unique name shared by all devices in a wireless network. The SSID is
Channel No. If your network is set to
Network Type The Network Type setting shows a choice of two wireless modes. Select Infrastructure if you want the PrintServer to communicate using an access point or wireless router. Select
Click the Save button to apply your changes, or click the Cancel button to cancel your changes.
The Wireless Tab > Security
Configure the wireless security of the PrintServer on this screen. The settings you set should match the settings of your wireless network.
If you do not want to use wireless security (not recommended), select None from the Security Mode drop- down menu.
Wireless > Security > None
Wireless Security
Security Mode To use WPA, select WPA Personal. To use WPA2, which is stronger than WPA, select WPA2 Personal. To use WEP, select the level of WEP encryption you want to use, 64 Bit Keys (10 Hex chars) or 128 Bit Keys (26 Hex chars), which is stronger than
Proceed to the instructions for your security method.
WPA2 Personal
Wireless > Security >
WPA Encryption Algorithm AES is the default algorithm. TKIP is also available.
WPA Shared Key Enter your Shared Key, which must have
Click the Save button to apply your changes, or click the Cancel button to cancel your changes.
8 |