Linksys PPS1UW manual Open the Printers folder Start = Settings = Printers

Page 22

Instant EtherFast® Series

1.Open the Printers folder (Start => Settings => Printers).

2.Right-click the IPP Printer and select Properties.

3.Click the Port Settings or Configure Port button (Details or Port tab, depending on your version of Windows). The Configure IPP Port screen (shown in Figure 8-3) will appear.

Figure 8-3

Note: Verify that USB 1 appears in the field beside the Select Device Port button. If it does not, click the Select Device Port button, and select USB 1.

There are two settings—Retry Interval and Retry Count—that can be adjust- ed if you have problems connecting to the IPP Server.

·Retry Interval sets the time interval (in seconds) between connection attempts. Increase this number if you have a poor connection, or the remote server is very busy.

·Retry Count sets how many connection attempts will be made. Increase this number if you have a poor connection, or the remote server is very busy.

EtherFast® Wireless-Ready USB PrintServer

IPP Client Setup for Windows 2000 and XP

Windows 2000 and XP have their own IPP Client, and there is no need to install the supplied IPP Client Software. To use this IPP Client with the PrintServer, follow this procedure:

1.Start the Add Printer Wizard.

2.Select Network Printer and click Next to see the Locate your Printer screen, as shown in Figure 8-4.

Figure 8-4

3.Select Connect to a printer on the Internet or on your intranet, and enter the URL of the IPP Server as follows, where ip_address represents the IP Address of the IPP Server, and 631 represents the port number.

Port 1

ip_address:631/ipp/P1

Note: These entries are case sensitive. They must be entered as shown, with “ipp” in lowercase, and P1 in UPPERcase.

37

38

Image 22
Contents EtherFast Wireless- Ready USB PrintServer Copyright & Trademarks Table of Contents Package Contents Instant EtherFast Wireless-Ready USB PrintServerFeatures IntroductionWireless-Ready USB PrintServer’s LEDs Wireless-Ready USB PrintServer’s PortsFinding the Wireless-Ready USB PrintServer’s Default Name Hardware InstallationOverview Autorun Bi-Admin Management Utility Installation Windows Driver SetupAt this point, you must have Installing the Wireless-Ready USB PrintServer’s Drivers Instant EtherFast Series Instant EtherFast Series Bi-Admin PrintServer Management Starting the Bi-Admin Management UtilityBi-Admin Help Files Using Bi-AdminSetting the Wireless-Ready USB PrintServer’s IP Address Refreshing the Device List Refresh IconRestoring Factory Default Attaching Bi-Admin to a Remote Linksys PrintServerResetting the Wireless-Ready USB PrintServer Changing the Device NameOpen your web brows Accessing the Web-Based UtilityWhen the Configure Server screen appears ServerWireless TCP/IPStatus Advanced PropertiesAppleTalk Mail Server IP Address is Internet PrintingLogical Printers NetBEUI SnmpWindows IPP Client Setup Internet Printing Protocol IPPInstallation is now complete Changing the IPP Port SettingsOpen the Printers folder Start = Settings = Printers IPP Client Setup for Windows 2000 and XPIPP printer is now ready for use Using IPP Printers General Printing Issues Appendix a TroubleshootingHardware Issues Appendix B About Bi-Directional PrintingAppendix D Glossary Instant EtherFast Series Instant EtherFast Series Instant EtherFast Series Appendix E Specifications LANAppendix G Warranty Information Appendix F EnvironmentalSales Information Technical Support RMA Issues FaxAppendix H Contact Information Web FTP SiteCopyright 2002 Linksys, All Rights Reserved