Linksys PPS1UW manual Installing the Wireless-Ready USB PrintServer’s Drivers

Instant EtherFast® Series

3.The next screen that appears, shown in Figure 4-3, will request you to choose a destination folder. You can either use the default folder by clicking the Next button or choose an alternate folder by clicking the Browse button and selecting a folder from the window that pops up. Click the Back button to take a step backward in the installation, or Cancel to forgo installation.

Figure 4-3

4.The Bi-Admin Management Utility will now be installed. When it is com- plete, you will see Figure 4-4. Click the OK button and continue to the next section, Installing the Wireless-Ready PrintServer’s Drivers.

Figure 4-4

For more information about Bi-Admin Management, go to Chapter 5: Bi-

Admin: PrintServer Management.

Note: After you have run the Autorun program and installed the Bi- Admin Management Utility, the Autorun will still run every time you insert the CD. Do NOT install the Bi-Admin Management Utility again. Click the EXIT tab to prevent duplicate installation.

EtherFast® Wireless-Ready USB PrintServer

Installing the Wireless-Ready USB PrintServer’s Drivers

Note: Make sure you have an IP address for the computer and an IP address for the PrintServer. If you need to assign an IP address to the PrintServer, go to Chapter 5: Bi-Admin: PrintServer Management.

1.To begin driver installation, click the Start button, and select Run. Type D:\Driver\Win9xnt\setup.exe (where “D” is the letter of your CD-ROM drive) in the Open field that appears. Click the OK button.

Figure 4-5

2.The Welcome screen appears. Read the text that appears, and click the Next button.

Figure 4-6

9 10