Fujitsu 510 manual Agency Compliance, UL Notice

Page 3

Agency Compliance

UL Notice

Caution

For continued protection against the risk of fire, replace only with the same type and rating of fuse.

Caution

The battery pack and batteries inside the Pen Computer are not user replaceable. Please contact Fujitsu Personal Systems, Inc. Service Center for replacement of all batteries.

Caution

Danger of explosion if CMOS battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to manufacturer's instructions.

Warning

CMOS battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.

Caution

The battery used inside the battery pack may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 100 degrees C (212 F) or incinerate. The battery used inside the battery pack must be replaced at Fujitsu Personal Systems Inc.’s Service Center only. Dispose of used battery promptly. Keep away from children. If swallowed, contact a physician at once.

Caution

Overcharging, short circuiting, reverse charging, mutilation or incineration of the cells must be avoided to prevent one or more of the following occurrences: release of toxic materials, release of hydrogen and/or oxygen gas, rise in surface temperature. If a cell has leaked or vented, it should be replaced immediately using protective gloves. If and when necessary, these cells must be replaced with identical new ones from the same manufacturer.

If a cell to be replaced is connected with other cells in series, it is recommended that the other cells be replaced with the new ones at the same time.

Image 3
Contents User’s Guide Page UL Notice Agency ComplianceFCC Notice FCC Notice for Systems With Built-In Wireless LAN AdapterCanadian DOC Compliance Page Table of Contents Viii Getting Started Point 510 Pen Tablet Features FrontPower Button System Features and ControlsPen Holder DC Power Port Status Lights on the Point 510 Pen Tablet Status LightsGetting Started Point 510 Accessories Accessories Included with the Point 510 Pen TabletOptional Accessories Getting Started Power Using the Point 510 Pen TabletPower States Using the Power Button as a Suspend/Resume ButtonStarting the Pen Tablet Using the Power Button as an On/Off Button Using the PenEnsuring Pen Accuracy Table below shows each hotpad icon and how to use it Using HotpadsSuspending and Resuming Operation Entering Suspend Mode Suspend/Resume Power ButtonResuming Operation Entering Suspend Mode On/Off Power ButtonOther Suspend/Resume Issues Charging the Battery PackFollowing table shows how battery lights show battery status Removing the Battery Pack Removing and Installing the Battery PackUsing Connectors and Peripheral Interfaces Conserving Battery PowerPoint 510 Pen Tablet Connectors- Right PC Card slot Optional Wireless RF LAN TransceiverShutting Down the Point 510 Pen Tablet Care and Maintenance Protecting the Display ScreenStoring the Point 510 Pen Tablet Cleaning the Display Screen Protecting the Point 510 Pen Tablet in Harsh EnvironmentsTaking Care of the Pen Determining When to Perform Pen Calibration Calibrating the Point 510 Display ScreenPerforming Pen Calibration Suspended Pen Tablet Will Not Resume Solving ProblemsInfrared Data Transfer is Not Working Display Screen Is Blank or Difficult to ReadWireless LAN Signal is Interrupted Audio Volume Too LowCursor Is Not Tracking Pen HDD IndexIndex-2 Index-3 Index-4