Fujitsu 510 manual Solving Problems, Suspended Pen Tablet Will Not Resume

Page 34

3.Perform the calibration steps according to the instructions on the screen. The calibration utility displays cross-hairs in each corner of the screen, one at a time. Tap the center of each cross-hair as it appears, holding the pen the same way you would hold it while using the pen tablet.

4.After you have tapped all of the cross-hairs, a box appears with three buttons. Tap one of these buttons to accept, cancel, or retry your calibration settings. If you don’t tap any of the buttons within 20 seconds, the Point 510 pen tablet goes back to the previous calibration settings. The buttons are:

OK: If you are satisfied that you tapped the cross-hairs accurately, tap OK. Your taps are then used to calibrate the screen.

Cancel: If you do not want to use your taps to calibrate the screen, tap Cancel. Your taps are not used and the previous settings are used.

Recalibrate: If you want to try again, tap Recalibrate. The calibration instructions reappear.

Solving Problems

Solutions to some common problems are described in this section. If you are experiencing a problem with your Point 510 pen tablet that you cannot solve by taking the actions described, contact the computer professional at your site who maintains the Point 510 pen tablets.

Suspended Pen Tablet Will Not Resume

If the Point 510 pen tablet will not resume operation after operation was suspended, check the following possible causes:

•The Point 510 battery pack might be defective, or discharged to the critically low level. When the battery pack cannot supply adequate power, the pen tablet is forced into suspend mode to avoid a total power failure. To correct this problem, either connect an external power supply (such as the AC adapter or charging cradle) or install a charged battery pack in the Point 510 pen tablet.

•The pen tablet might be too hot. To avoid damage to heat-sensitive components, the pen tablet enters suspend mode if it gets too hot. The Point 510 pen tablet cannot resume operation until it cools off to a predetermined temperature. Move the pen tablet to a cooler location and prevent direct sunlight from shining on it.

3-4

Care and Maintenance

Page 33 Page 35
Image 34
Page 33 Page 35
Contents User’s Guide Page Agency Compliance UL NoticeFCC Notice for Systems With Built-In Wireless LAN Adapter FCC NoticeCanadian DOC Compliance Page Table of Contents Viii Point 510 Pen Tablet Features Front Getting StartedSystem Features and Controls Power ButtonPen Holder DC Power Port Status Lights Status Lights on the Point 510 Pen TabletGetting Started Accessories Included with the Point 510 Pen Tablet Point 510 AccessoriesOptional Accessories Getting Started Using the Point 510 Pen Tablet PowerUsing the Power Button as a Suspend/Resume Button Power StatesStarting the Pen Tablet Using the Pen Using the Power Button as an On/Off ButtonEnsuring Pen Accuracy Using Hotpads Table below shows each hotpad icon and how to use itEntering Suspend Mode Suspend/Resume Power Button Suspending and Resuming OperationEntering Suspend Mode On/Off Power Button Resuming OperationCharging the Battery Pack Other Suspend/Resume IssuesFollowing table shows how battery lights show battery status Removing and Installing the Battery Pack Removing the Battery PackConserving Battery Power Using Connectors and Peripheral InterfacesPoint 510 Pen Tablet Connectors- Right Optional Wireless RF LAN Transceiver PC Card slotShutting Down the Point 510 Pen Tablet Protecting the Display Screen Care and MaintenanceStoring the Point 510 Pen Tablet Protecting the Point 510 Pen Tablet in Harsh Environments Cleaning the Display ScreenTaking Care of the Pen Calibrating the Point 510 Display Screen Determining When to Perform Pen CalibrationPerforming Pen Calibration Solving Problems Suspended Pen Tablet Will Not ResumeDisplay Screen Is Blank or Difficult to Read Infrared Data Transfer is Not WorkingAudio Volume Too Low Wireless LAN Signal is InterruptedCursor Is Not Tracking Pen Index HDDIndex-2 Index-3 Index-4
Top Page Image Contents